Search results

Who is towing with a discovery 2ltr and what mpg are you getting

passed one of these on the M74 motorway last night pulling a low loader with a pick up on the trailer not something you see very often did any one else spot it

I've been looking at how to break down large diamiter timber to put it through my processor looking at 10 to 12ft long uwards of 3ft diamiter straight grain wood. i'm wondering if anyone has tryed welding a blade to the bottom of a excavator bucket put the end of the timber against the blade...

Anyone having problems with the locking pins on the jcb tool carrier headstock snapping had a few go and it's looking like they have been over heat treated and now very brittle

Not sure which thread this should go so here it is . What does the hire of a firewood processor ,tractor and operator cost in your area ???

So had lot of firewood to cut and shift round the yard and and after pricing a log grab for the loadall and being the tight scots man i am remembered this old shear bucket i converted into a gravel separator many years ago and had since stopped using it it screamed out log grab trim a...

just your average bale trailer but getting past its best quickly and funds wont cover a new one so had to bring out the gas axe and the welder again so the old rotted and not even there in some cases bits were cut out more rot and more bits to weld in bit of paint might as well do it...

This is a side thread to my other question been offered more or less endless supply of 17.5 tyres and rims off 7.5 tonners 6 inch centres and stud spacing . As the trailer does 99% of its life on the road has anyone ever tryed putting longer studs in and putting them on duel on a agri axle like...

my only trailer not on hd tyres is my Fraser bale trailer its sitting on 12.5/75 15.3 as i'm looking into a 50k tractor i will need to up grade tires and rims do any of you know what size will go on and where i could get them thanks guys

Been used and abused for years till the side rotted out so gas axe was brought out few hours later and some box section all horizontal beams have a sloped section welded to the top to stop dung or dirt sitting on it all ribs are fish tailed to spread any forces wee drop paint and it's...

I split a lot of firewood for the farm and as i have a collection of vintage tractors i might as well use them to power all the different parts of the system so had a hunt round the farm for bits so 1. beer barrel oil tank 2. frame from an old yard scraper and add a few bits of scraps from...

Tines on the old dung grab were very past their best so priced up replacements tines and bushings all i can say was good job i was sitting down at the time over £1000 so plan B was hatched and after some PAD (plywood aided design ) the lower bucket is made out of 8mm steel plate with 10 mm...

bought a 1969 swept axel 135 to restore got most things done but the front grill is missing and as some will know there is 2 versions a 13inch and a 14.5 to 15 inch grill does anyone know which should be on mine

can't keep tires on my 4wheel steer handler tryed all makes of tyre , Would like to know how many hours your machine does on a set and what make they both are just to see it the make of handler makes any dif

looking for a fold down beacon mount for massey ferguson 300 series tractor preferably off a mid 90's tractor large cast alloy one needing one to finish off the restoration of my 399