I have a JCB 525-60T4 telehandler with a Kohler 3N71D3-1 engine. It had an EGR fault and would not start. It showed 2 fault codes, U0411 and P0488. The EGR housing / manifold was very corroded and needed replacing. Rather than buying a new EGR manifold and valve I had the EGR deleted from the...
Hello,
I have just bought a Claas Arion 530 and now find that it is throwing fault codes. Usually 7777h which is reduction in fuel pressure. This is then often followed by one or more of these: 7781, 7782, 7786, which are all related to the EGR valve. Also 771Bh tonight which is an air intake...
I am working at a 6290 that has a drive fault. The error code for faulty Reed switches in the f/r shuttle lever is on and it will drive in one direction but when you go to change direction, de-clutching or not, it will bring on the orange exclamation mark, beep and either stop driving or stick...
We've got a 2019 6175r with the 4600 display and premium radio. 2 or 3 times a day during use the Bluetooth disconnects and it switches back to the radio, it doesn't say 'bluetooth disconnected' it just jumps over to the radio and won't automatically reconnect as if it briefly loses power?? I...
Hello there is a problem with air conditioning in my class. The A / C compressor does not turn on. The E8 code and the inscription service flash on the air climate control screen. The amount of refrigerant in the system is ok, I checked the wires for the air conditioning compressor and the air...
Hi
Having a problem with our starter. I can normaply diagnose the issue but im stumped...
The starter is cranking the engine for say 1/4 a turn then it comes off and spins.
-battery reading 13v on both. Although i havent checked when cranking....
-removed the starter....fun in cold and loader...
Hi,
I have a 2007 JCB 3CX which wont start. The fuse in slot A1 is the Auxiliary Hydraulics fuse. Everytime I turn they key this fuse blows and cause the JCB to not start. Can anyone shed any light on what the problem may be? Could it be the Hydraulic Pump?
All help appreciated;
Thanks!
My lister2 clippers got temperamental yesterday and Then died I though it was a cable break as I have had that before... it's not the cable, it's also not the switch either. Anyone know the secret to remove the intermediate gear shaft that is preventing me opening up the machine further...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.