What kind of pump do people use for dirty water. I want to pump out yard water which has silage in too, not loads but enough to get in the filter of a petrol 2 inch pump. I'm hoping to fit a length pipe and pump it out to drain away, so high pressure could be handy. It also could be used to...
I have a t7245 ac which won’t start the pto using the hts. It will stop it ok but I have to reset the start stop switch to get it to restart. Code 007 comes up and the screen says ‘pto switch in the on position please switch on pto’. The automatic pto function is working fine.
Has anyone any...
Hello,
I recently bought Joskin Modul02 11000 ME from Austria year of production is 2008 .
Since it's my first time using the Joskin slurry tanks and using the trailing shoe I did not know that there was a macerator and that it needed to be (in my case) powered by hydrulic pipes from the...
Could any one give advise , i have just bought a second hand tanker and dribble bar , what hyd flow does it need to run at , i was thinking max flow but some advise would be helpful , thank you for any help .
hello, is anybody using an electric motor to power mixer wagon, sense electricity is 3 times cheaper than diesel. Here is a picture of the sistem around 10kW motor with reductor.
Occasionally I have to put my amazone uf 1602 on a massey ferguson 6718S dyna vt (normal tractor is a 6713S dyna 6) - the sprayer hydraulics work off the load sensing pipes on the tractor, when on the Vt it will switch off the front suspension or make it work funny as if it’s starving it of...
Hi lads, first of all il say I have a 6 bay slatted tank, 110ft long 15ft wide & 8ft deep. Have about 45 acres of silage ground. Tank gets emptied twice a year. I have my own silage outfit so have no problem in pulling power. I'm a young farmer so I'm hearing I get 60% tams for a tanker. It...
I have had the auxiliary oil tank off for repair on my JD 6930 premium, now it sounds like there is air in the system when I run the macerator on my slurrytank.
I didn't fill up the auxiliary oiltank with oil, could there be air trapped in the system, and if so. How do I release it?
Thanks.
Written by Justin Roberts from Agriland
Removing the solid fraction of slurry and returning the liquid to the lagoon has long been a common practice on the continent, but there now appears a determined push to popularise it in Ireland.
There are many advantages to removing the fibre from...
Hi lads & ladies . I am thinking of availing of the TAMS young farmer grant for a 2000g tanker & dribblebar. I have a 120hp massey 6cylinder. Is this enough power to operate a tanker that size ? Land is flat & not soft
Thanks
Been asked to look at clearing 130 acres of basically overgrown ,docks ,nettles grass etc . It wax prime grazing ground 3 yrs ago but has been given to a charity who have let it get seriously out of hand.
Question ....
If I mow it and bale it , is it any good to go into a digester ?
Written by Justin Roberts from Agriland
Methane has been hitting the headlines of late as a significant greenhouse gas, even at concentrations of as little as 1,900 parts per billion.
The methane burden in the atmosphere has been calculated to be increasing by 22 million tonnes/yr due to the...
bedding
carbon
cattle
dairy
diesel
farmyard
front linkage
gas
harvest
harvesting
macerator
management
methane
new holland
parts
savings
separator
slurry
storage
stress
t6
t7
transport
Have seen a few secondhand for sale. Know very little about them, do think that I probly would source the macerator and make my own to suit the tanker but just a thought this might suit as a quick start to go straight one tanker.
It seems to be the smaller ones 6.5 metre, but I haven't looked...
I have a 05 reg massey fergusson 6480, closed centre hydraulics, this past while (last 500hrs) when operating anything hydraulic related through the spools( slurry tank macerator, lift rams on mower, rear door of round baler, tipping trailer) the pressure and speed is very poor, especially once...
Hi all,
We have a 12m slurry quip dribble bar and the pipes are kinking when it's folding up. Has anyone else experienced this and does anyone have some suggestions to stop it happening.
Thanks
Hi all,
Does anyone else have trouble getting slurry to o through the dribble bar when it's thicker. It's fine on the splash plate but it's really slow through the dribble bar. Looking at it in the pit you would think its fine to go through. Is there any tips to get it going better or are they...
We got a leaflet and associated info through early this year saying as of January 1st 2023 all slurry on a farm in Scotland with over 200 cattle in total must apply slurry using a low emissions system, and there’s a grant to support this.
We’ve ordered one but I can’t say the idea fills me with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.