rtk

Got a 250 for guidance in a ranger for avadex work but thinking about putting easy steer onto it . Just really to make it easy on me only thing is that it is non power steering . Would it be strong enough to op the steering as steering is fair easy .

Hi all, just bought a small sp sprayer, it has a delta 34i which has a faulty screen. What is available as in guidance/spray controller or do I just fix the current one and use foam markers? Cheers

Where would we start, we're thinking of putting auto steer on our sowing tractor. Are they hard to move from 1 tractor to another? Basic approx price? Make? Thanks.

Under request from @Bokey I have decided to dedicate a thread to the trials and tribulations on the farm, I shall endeavour to splice the good with the bad. A bit about us, 600 acres all told, 450 cropable, 8 years into organic, mainly arable with a few wooly critters, an impatient old man and...

Just wondering if anyone can help, how do I add an offset to my already mapped boundary, I’ve done it before but can’t remember how I did it now, want to use it with my turn automation. Using Starfire 6000.

Just got targeted again last weekend which is two years since their 1st visit . Running NH tractors but it has been suggested to me that certain breeds of tractor are less targeted due to the difficulty of getting what they want . Breed in question was that JDs gps is built in more so at worst...

We will soon be looking for a new 300 hp tractor, does anyone have experience of Case Optum tractors. Historically we ran Case Magnums and Quadtracs but always felt quality was a bit lacking backup however was good from Does and I have no doubt this is still true. Really wanted a Fendt 828 but...

Trying to setup my basestation in the Fieldstar 5 terminal, but I can't find the settings for NTRIP. I was planning to use RTK2GO as caster. Dealer says I have to unlock💰RTK to be able to setup NTRIP. Has anyone managed to set up this somehow without unlocking?

I have an amazone uf sprayer with amatron 3 computer using with gps switch section controll in amabus mode, working great... I also have ZA-M spreader working with amados + computer.... now I want to upgrade my spreader to work with amatron3, so I dont need to replace screen al the time, and...

Have got a lemkin solitaire 9 drill I was wanting to put tramline markers on. Lemkin are wanting a small fortune for them. Has anyone made their own or fitted a kit from some else.

Hello everybody, Farmer in France, i am having issue setting up my own rtkbase working with a Claas terminal s10 properly. The signal is not stable in the field, rtk float is quite often there instead of RTK Fix signal. Sim card is multi operator. Do you know what rtcm message would make it...

2016 7720 steer ready with an aftermarket Agleader Incommand on RTK. The tractor is sitting approx 25cmm off the line always to the right. The problem was intermittent. I had this before and the problem was with the tractor rather than the Agleader system. Problem sorted out by dealer at that...

Can anyone shed any light on the current xFill settings, and are they VRS supplier dependent? I'm being told 2 different datum choices by different people. Frequency 1545.4900mhz Baud rate 2400 xFill datum, choice of: Thanks in advance.

Just wondering how people are getting on with these systems? TIA

Hi what do you guys think of this as ready to go base station kit?

We are having issues with our T7.315. New last year and FMX installed by dealer and GPS supplier (well known national firm) at local tractor dealership. It is on RTK with a local Trimble base station. We run three FMX units in CNH tractors and the other two are working fine. Last autumn and...

Recently purchased a challenger sprayer with the above setup .. I've been told its unlocked to rtk but ive no idea where the modem or sim card goes to use it at a higher level than egnos. Can anyone shed any light on this? Also today it wouldn't pick up gps signal... Im not sure if this was...

we have a worst thread so for balance what’s the best tractor of all time ?

Some of the Chinese selling sites (Ali etc) are now selling Trimble gear like cables and antenna along side the Rolex watches and Gucci handbags. Anybody ever tried it? I fancy a new ag15 antenna for less than 100 euros.

Is there an other way to make a fully functional field boundary then using the headland mode? I would like to make them by using field mark option, while driving autopilot on exsisting ab lines, which I have already made in my fields… I tried that today, but when I finish boundary, it is saved...