Accord disc coulters

[AKA]

Hi, I am currently changing the discs on my Kv/accord combi drill and some of the disc bearings are worn so replacing them too as I go. Is there an easy way to pull the bearing and hub of the shaft as they are very tight. Can’t get bearing pullers on very well as back of the hub is too close to the coulter arm, won’t shift with a hammer if I hit them from the back of the hub either. The hubs are only plastic so easily damaged. Is there a proper ‘tool’ to pull them off?
any help greatly appreciated
Tia

 

[yellowfrog]

got myself a draper insert bearing puller kit for mine about£40. you have to rip out seal, rip out ballbearing cage then put inserts in bearing then just pull off turning puller. done all mine(23) never had to replace plastic holders. 2 types of kit small draper stock number 43137 and large stock number 43136. almost sure i had the large. as bearing is a 6305 2rs fantastic kit worth the money as those plastic holders aint cheap . hope this helps steve

 

[AKA]

Thanks @yellowfrog i have searched drapers web page and they have discontinued both them puller sets
thanks anyway.

 

[yellowfrog]

Thanks @yellowfrog i have searched drapers web page and they have discontinued both them puller sets
thanks anyway.

available on amazon.both sets . also ebay