Adjusting Lexion header auger height tips please?

Pilatus

Member
Just about to adjust the auger on the Lexion Vario 1200 header to help barley feed in smoother when we get combining again. Looks a fiddly job adjusting the split auger any tips to make the job a little easier would be appreciated. Many thanks.
 

snarling bee

Member
Arable Farmer
Location
Bedfordshire
On my 1230 vario I had to support the reel in the centre with a loadall to be able to remove the rams to get access to the bolts/nuts. Stupid design.
A week later I noticed that the centre was further forward than the ends. :banghead::banghead:. The only adjustment for that is the tolerance in the slots, but potentially possible. You need to check that before you reattach the centre reel ram.

.......................I now run a MacDon.
 

Pilatus

Member
The way to be to get the centre support auger washers/ bolts is to let the reel down as far as it will go,one can then get the bolts /washers reasonably easily.
I only found how to do the above by phoning Claas Western Cirencester
 

Will you help clear snow?

  • yes

    Votes: 68 31.6%
  • no

    Votes: 147 68.4%

The London Palladium event “BPR Seminar”

  • 12,311
  • 180
This is our next step following the London rally 🚜

BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth

Join us @LondonPalladium on the 16th for beginning of UK business fight back👍

Back
Top