Ag Leader - Guidance Lines

ArheeNZ

Member
Arable Farmer
Hi,
I’m running a Incommand 800 with a RTK unlocked 6500 receiver and Ontrac 3 steering. I’ve been playing around for a long time now with the best way to setup my guidance lines for steering off of each fence line.
I ended up setting up on atv, chose general guidance and set guidance width to 0.0001 metres and done an AB line off of each fence. Reason being, I can pull into paddock with whatever implement on and it will pre populate how far it needs to shift me over to position me exactly where I intended off of fence. But now for some reason it only does it when I load individual line, soon as I load it as group of 4 lines it doesn’t pre populate how far to shift.

Also since upgrading to version 7.0 if I try to say guidance width is smaller than 0.1m the screen freezes. I realise it will be processing a lot of small lines doing this but still worked fine on version 6.6

Any ideas or solutions to this?
 

Make Tax Digital Software Poll

  • Quickbooks

    Votes: 33 16.7%
  • Sage

    Votes: 20 10.1%
  • Xero

    Votes: 91 46.0%
  • Other

    Votes: 54 27.3%

Man fined £300 for bonfire-related waste offences

  • 160
  • 0
Written by William Kellett from Agriland

court-640x360.jpg
A man has pleaded guilty at Newtownards Magistrates’ Court to waste offences relating to a bonfire next to the electrical sub-station on the Circular Road in Newtownards, Co. Down.

Gareth Gill (51) of Abbot’s Walk, Newtownards pleaded guilty to two charges under the Waste and Contaminated Land (Northern Ireland) Order 1997, for which he was fined £150 each and ordered to pay a £15 offender’s levy

On June 25, 2018, PSNI officers went to Gill’s yard, where they found a large amount of waste consisting of scrap wood, pallets, carpet and underlay.

Discussion with Northern Ireland Environment Agency (NIEA) officers confirmed the site...
Top