Hi,
I’m running a Incommand 800 with a RTK unlocked 6500 receiver and Ontrac 3 steering. I’ve been playing around for a long time now with the best way to setup my guidance lines for steering off of each fence line.
I ended up setting up on atv, chose general guidance and set guidance width to 0.0001 metres and done an AB line off of each fence. Reason being, I can pull into paddock with whatever implement on and it will pre populate how far it needs to shift me over to position me exactly where I intended off of fence. But now for some reason it only does it when I load individual line, soon as I load it as group of 4 lines it doesn’t pre populate how far to shift.
Also since upgrading to version 7.0 if I try to say guidance width is smaller than 0.1m the screen freezes. I realise it will be processing a lot of small lines doing this but still worked fine on version 6.6
Any ideas or solutions to this?
I’m running a Incommand 800 with a RTK unlocked 6500 receiver and Ontrac 3 steering. I’ve been playing around for a long time now with the best way to setup my guidance lines for steering off of each fence line.
I ended up setting up on atv, chose general guidance and set guidance width to 0.0001 metres and done an AB line off of each fence. Reason being, I can pull into paddock with whatever implement on and it will pre populate how far it needs to shift me over to position me exactly where I intended off of fence. But now for some reason it only does it when I load individual line, soon as I load it as group of 4 lines it doesn’t pre populate how far to shift.
Also since upgrading to version 7.0 if I try to say guidance width is smaller than 0.1m the screen freezes. I realise it will be processing a lot of small lines doing this but still worked fine on version 6.6
Any ideas or solutions to this?