Backing gate help

[Moorlands]

Been donated a backing gate!
By a friend that’s put robots in problem is I think he removed it using jcb with grab on [emoji85]
Just about got it assembled but could do with a wiring diagram of one.
It’s a wesfalia commander 07

 

[Real cool]

I put some in a few years back Cheshire I think I think there might be one in the file

 

[Blue.]

Been donated a backing gate!
By a friend that’s put robots in problem is I think he removed it using jcb with grab on [emoji85]
Just about got it assembled but could do with a wiring diagram of one.
It’s a wesfalia commander 07

Bad to see from the pictures but is that wires underneath?
Any road looks like a feed motor drive so 24v

I’ve my gate rigged up on a son off 4ch pro,this means I can do forward and reverse via my phone,a key fob or buttons on the box.?

 

[Moorlands]

Bad to see from the pictures but is that wires underneath?
Any road looks like a feed motor drive so 24v

I’ve my gate rigged up on a son off 4ch pro,this means I can do forward and reverse via my phone,a key fob or buttons on the box.[emoji106]

Yeah your correct it’s a feed/windscreen wiper motor 24v yeah wires had been cutting at control box end with enough left to see which should go where. But at motor end they’ve just been literally ragged out!!! ?‍
Sounds good having phone and key fob controls.

 

[Blue.]

Yeah your correct it’s a feed/windscreen wiper motor 24v yeah wires had been cutting at control box end with enough left to see which should go where. But at motor end they’ve just been literally ragged out!!! ?‍
Sounds good having phone and key fob controls.

Your going to have 2 wires to each limit switch and the feed motors were generally 4 wires.

 

[Moorlands]

That would make sense with the number of wires so guessing the 4 wires are the motor wires so just try push those together and see what happens

 

[Blue.]

That would make sense with the number of wires so guessing the 4 wires are the motor wires so just try push those together and see what happens

Connect the motor via the 4 wires,the limit switches will break the contact once either fully forward or back.the limit switches Will need wiring in the appropriate lines though.