basic ploughing question

Howard150

Member
Location
Yorkshire
For conventional ploughs, as a starting point then set the lower links so that the plough is at least level in work (across) Set the top link so that the plough is parallel to the ground. As you progress and other settings come into play then slightly leant over toward the ploughing.
For both reversible and conventional then there may be a choice of attachment points on the tractor or the plough - or both. In general terms if the lower links are lower at the tractor end when the plough is in work then the tractor will tend to pull the plough in - useful in hard ground to assist penetration. If they are higher at the tractor end then they will help to stop the plough penetrating too readily and help keep the plough out in soft ground. Small points to somebody in the know but all aids toward maintaining even depth and straightness.
For reversible ploughs then make sure that the lower links are set level when on level hard ground (yard concrete being best) with the lift links the same length, you must ensure that both stops on the turnover are set the same in order to maintain level work without peaks and troughs, and that the top link is set correctly. High on the plough for soft ground, low on the plough for hard ground.
A number of people plough with stabilisers. If the plough is going right, set in the right place on the cross shaft they are not necessary. You will however need something to stop the lower links fouling the tyres as the plough swings when in the raised position.
Hope this helps.
 

SFI - What % were you taking out of production?

  • 0 %

    Votes: 80 42.1%
  • Up to 25%

    Votes: 67 35.3%
  • 25-50%

    Votes: 30 15.8%
  • 50-75%

    Votes: 3 1.6%
  • 75-100%

    Votes: 3 1.6%
  • 100% I’ve had enough of farming!

    Votes: 7 3.7%

Red Tractor drops launch of green farming scheme amid anger from farmers

  • 1,294
  • 1
As reported in Independent


quote: “Red Tractor has confirmed it is dropping plans to launch its green farming assurance standard in April“

read the TFF thread here: https://thefarmingforum.co.uk/index.php?threads/gfc-was-to-go-ahead-now-not-going-ahead.405234/
Top