Bobbins bent up on wrapper.

[Greythundercloudys]

Obviously this was pointed out on another thread, they must have be like that since l got it years ago, must have taken a bit of abuse to bend them, if l got them straightened maybe that would cure my plastic ripping problem.

 

[Wellytrack]

You didn't notice those bent to now? Straighten them then and report back with findings........

 

[Still Farming]

Whose dropping bales on or off too rough??

 

[Greythundercloudys]

On that machine they sit at a kinda angle anyway. I see wardsman has a mchale on website, if he gave me 1800 for a trade in he could have it.

 

[Wellytrack]

On that machine they sit at a kinda angle anyway. I see wardsman has a mchale on website, if he gave me 1800 for a trade in he could have it.

Or you could just fix the wrapper?

 

[Greythundercloudys]

Iv been trying to fix it for years, l like the mchale cut and hold with that arm thingy.

 

[Dave W]

On that machine they sit at a kinda angle anyway. I see wardsman has a mchale on website, if he gave me 1800 for a trade in he could have it.

You'll be declaring all its faults I assume

 

[Greythundercloudys]

Its only got one fault, but yes, although when l bought it the guy didn't say about to me. But that's my fault l suppose.

 

[Wellytrack]

Iv been trying to fix it for years, l like the mchale cut and hold with that arm thingy.

I had a parmiter TR86 with a modified single acting ram as the cut and hold, it worked just fine. I did however spend up to £500 quid on it over a few years on new belts, a new tyre and new roller bearings but that's just maintenance..