Carraro axle king pins

[serf]

Got this 2 piece king pin for bottom of swivel come and its tight fit to say the least , any one know if the end cone is meant to swivel on the end of king pin or can all the swivel be done direct onto bearing , this is the old one and the cone runs free on pin !

 

[Farmer_Joe]

@masseybreaker

 

[bobk]

Got this 2 piece king pin for bottom of swivel come and its tight fit to say the least , any one know if the end cone is meant to swivel on the end of king pin or can all the swivel be done direct onto bearing , this is the old one and the cone runs free on pin ! View attachment 1050451

What tractor

 

[serf]

Zetor

What tractor

 

[bobk]

Zetor

Oh ,

 

[serf]

Oh ,

Not mine I was gifted it

 

[agrimax]

The cone should be a tight fit on the pin.

 

[serf]

The cone should be a tight fit on the pin.

Good because it's FT , I had to sand it down to get it on then knock it on and thought have I done the right thing? Because that won't come off again without heat !

 

[ACEngineering]

Good because it's FT , I had to sand it down to get it on then knock it on and thought have I done the right thing? Because that won't come off again without heat !

they are common too work loose, you press them on and with Loctite. to get them off you cut the bearing with grinder and carefully grind away once you get close to the pin the bearing will crack and then knock off. (normally they have worn loose anyway and pins scrap)

 

[ACEngineering]

Good because it's FT , I had to sand it down to get it on then knock it on and thought have I done the right thing? Because that won't come off again without heat !

there should be bevel spring washers on there too.

 

[serf]

there should be bevel spring washers on there too.

No washer on old one and no waser in pack of new , and to late for locative now ....

 

[ACEngineering]

No washer on old one and no waser in pack of new , and to late for locative now ....

Then theres nothing to hold grease in and keep crap out as them pins have little ridge on them designed to take the bevel washer. They would be bought as seperate parts.

 

[serf]

Then theres nothing to hold grease in and keep crap out as them pins have little ridge on them designed to take the bevel washer. They would be bought as seperate parts.

Think I may have misunderstood , you mean big washers that sit on the top of bearing inbetween axle stump and swivel housing , yes have got them , I thought you meant sandwiched inbetween the cone and pin above ??