Claas 255RC round baler- managed to pull input lead from control box

[Red Fred]

Oh dear, I finished the last hay bale, disconnected the baler and drove home, forgetting to put the control box back in its holder. As a result, I pulled the lead clean out of the back of the box. No further damage appears to have been done, but I wondered whether anyone knew where the wires go, in the multiconnector inside the box. There appear to be 15 black wires and one green/yellow one, so I thought I would ask first in case I can just reconnect it before sending it to Mr King's for a look. If anyone had a diagram, I would be most grateful. Thanks!

 

[Matt L]

Should be in the parts book. Each wire will have a code written on it so you may need to strip back the insulation to see the individual numbers.
If you only slice down its length rather than remove a section of the sheath you can seal it with heat shrink tubing after.