YELROM
Member
- Location
- North Yorkshire
Just pulled the rake out of the shed, gone to open it up and an oil pipe going from the main frame up into the box section arm that lifts the rotor has burst. The oil pipe fitting on the end of the ram is about 18" up inside the box section and there is not enough room to get a spanner in to undo it,do i take out the ram mounting pin and extend the ram so the fitting comes further down the box section if that makes sense or is there an easier way?
In middle of pic 1 is the pipe that has burst and in the middle of pic 2 is the pin holding the ram
Pic 1
In middle of pic 1 is the pipe that has burst and in the middle of pic 2 is the pin holding the ram