CNH PLM Auto Guidance swath

[Peaceagri]

Probably a simple question, but how do you get your swaths where you have driven to show/highlight on your map? To highlight behind your guidance line I mean. Is it one of the layout tabs that you need to select on your custom Run screens you set up?

 

[miniconnect]

Probably a simple question, but how do you get your swaths where you have driven to show/highlight on your map? To highlight behind your guidance line I mean. Is it one of the layout tabs that you need to select on your custom Run screens you set up?

You'll need to turn on Work control, (I think that's what it's called) it'll be in one of your run screens, U think it's no4 on mine, fair chance you'll be different.

 

[GPS_Support_2014]

I assume you are on a T6 or T7 tractor....if yes, then on your display go to Performance > Prod > Work Control

Work Control = ON will paint coverage constantly
Work Control = Auto Mode will paint coverage based on hitch or remote valve (depends what you have set in Toolbox > Impl)

You can add the Work Control selection to one of the Run Screens also by using the Toolbox > Layout screen

 

[Peaceagri]

Thank you, I will check it out when back at tractor. Manual is not great.