Zetor
Member
- Location
- Northumberland
Are Relentless plant still going? Lanarkshire, They did mine and been fine
Yes it's a pest of a job, but doable for anybody with time and patience. Best to pressure wash the bolts dead clean then gas them off but make sure you run a grinder over the contacting surfaces of your pads and new chains to remove all rust and paint. You really don't pads rattleing slack down the line. milwaukee is great building up the tracks but nothing is a substitute for a 10 foot pipe as tight as it will go. On 20 tonners one on each end of a 1 inch tee bar. Seen other professional outfits torque less and it all run slack, never seen a bolt snap yet from over tightening..Cost me £2350+vat for chains, sprockets an bolts for my doosan 14t from MST.
Tracks off, set them on their side and gas away. Milwaukee gun would be good for the new bolts!