Drill chuck for a angle grinder

ste

Member
Livestock Farmer
Location
Derbyshire
Does anyone know if its possible to get a drill chuck to fit to a 115mm cordless angle grinder, or a die grinder chuck to fit one?

Its for a very occasional/probably never used job on the railway, using a sanding drum to remove some material on some steelwork. Current plan is a sanding drum kit in a cordless drill but looking at using and grinder as we have them as well. Can get an actual die grinder to use the same batteries as our impact guns and grinders, but baulking at the cost as it may never get used.
 

ste

Member
Livestock Farmer
Location
Derbyshire
Does a grinder not rotate at something like 22000 rpm?bit fast I would imagine!!! Will a flap disc not do the same job?

die grinders are 25000 rpm so a grinder will do fine, either have to use drum sander bits or die grinder bits as it for pin holes
 

ste

Member
Livestock Farmer
Location
Derbyshire
That might do the job, just depends on if it holds the sanding drum spindle central

For a tenner I'll order one and see
 

SFI - What % were you taking out of production?

  • 0 %

    Votes: 80 42.3%
  • Up to 25%

    Votes: 66 34.9%
  • 25-50%

    Votes: 30 15.9%
  • 50-75%

    Votes: 3 1.6%
  • 75-100%

    Votes: 3 1.6%
  • 100% I’ve had enough of farming!

    Votes: 7 3.7%

Red Tractor drops launch of green farming scheme amid anger from farmers

  • 1,293
  • 1
As reported in Independent


quote: “Red Tractor has confirmed it is dropping plans to launch its green farming assurance standard in April“

read the TFF thread here: https://thefarmingforum.co.uk/index.php?threads/gfc-was-to-go-ahead-now-not-going-ahead.405234/
Top