Ez pilot steering adaper

[Case140]

Any guys know where I would get a trimble ez pilot steering adapter plate for a 2003 case 140 mxm? It is approx 17mm spline - seens to be a lot smaller than the Tm one. Pm if prefer. Thanks

 

[Slick]

How many splines on the shaft?

 

[Slick]

Part no. 78100-32-RS is the one for CIH MXM and NH TM.
40 spline
major dia. 17.704mm
minor dia. 16.662mm
Vantage England and Wales can supply them.

 

[Case140]

Part no. 78100-32-RS is the one for CIH MXM and NH TM.
40 spline
major dia. 17.704mm
minor dia. 16.662mm
Vantage England and Wales can supply them.

You are correct ?. 40spline and sizes as quoted. Thanks a million. I will contact vantage in am but talking to a couple of farmers here I wont be buying as ?????!! Planning old steering wheel for the splined boss, half an hour on lathe and welder ...............

 

[reb1952]

We put Ez-pilot on Case 1394 forward control SP sprayer. Adaptor was the centre from an austin A35 steering wheel (remember them ?)
Bit of machining with the angle grinder etc. and Bob's your uncle. However its easier to mark tramlines with an old cultivator frame with two flexitines on it with 7" sweeps to just scrat marks to follow. Using the"big" tractor that normally has the gear on in for drilling, ferting, etc. We direct drill at different angle every year but use the same tramlines. just cant see them sometimes in chopped straw or cover crops.

 

[Case140]

Ko

We put Ez-pilot on Case 1394 forward control SP sprayer. Adaptor was the centre from an austin A35 steering wheel (remember them ?)
Bit of machining with the angle grinder etc. and Bob's your uncle. However its easier to mark tramlines with an old cultivator frame with two flexitines on it with 7" sweeps to just scrat marks to follow. Using the"big" tractor that normally has the gear on in for drilling, ferting, etc. We direct drill at different angle every year but use the same tramlines. just cant see them sometimes in chopped straw or cover crops.

Thanks for that. I got an old (free!) Case steering wheel, cut out the boss, machined in lathe to fit and welded in position. Half an hour and sorted! Running the cables is a much harder job but am working at it any spare time I have?

 

[Case140]

Sorry cant seem to stop double upload of pix?