farm force ULTRA TILTH

[somaled]

hope someone can help
do they have a parts /manual for one of these
cant work out how to take the bearing cover off to get to nut holding the bearing in place to replace a couple of bearings
thanks in advance

 

[Alistair Nelson]

hope someone can help
do they have a parts /manual for one of these
cant work out how to take the bearing cover off to get to nut holding the bearing in place to replace a couple of bearings
thanks in advance

Good evening, there is a hub cap on the bearing housing on the opposite end to the hub which had 2 holes in to turn it off when new. They’ll have probably worn by now so weld a nut on and then turn it off normal way to get in.

 

[Flat 10]

I bought new legs and bearings from pan anglia that were sourced in Germany. Not unreasonably priced. I forget the make (skf?????) but I believe that they are the same as cousins patriot ones.

 

[Alistair Nelson]

Yes the hubs discs etc come from a firm called industriehof in Germany and can be sourced via MDT, pan Anglia etc. The bearings, seals are std and can be sourced from usual sources the hubs and housings are only available from them. Various firms used them cousins, knight, farm force

 

[newhollandcruzr]

Yes the hubs discs etc come from a firm called industriehof in Germany and can be sourced via MDT, pan Anglia etc. The bearings, seals are std and can be sourced from usual sources the hubs and housings are only available from them. Various firms used them cousins, knight, farm force

Hi Alistair , as you know your farm force stuff ! i have a 4m folding drill fixed to ultimate do you no if the distribution head cover is the same as an Accord ? many thanks

 

[Alistair Nelson]

Sadly not as yours will be Ally and an accord will be plastic both 32 outlet and same sized input stack but slightly different. Sorry

 

[newhollandcruzr]

Thanks

 

[newhollandcruzr]

I don't suppose you know where i might find one ?? ours has worn through and I've bodged with a washer ! Seems to be ok but would like a new one if possible as the outfit does a great job for us.

 

[Nearly]

Andy Guest?

 

[basford]

Covenbrook make their own distribution heads

 

[Alistair Nelson]

You’ll be lucky if I’m honest but swooping the head isn’t a big job and I’m sure Andy guest will have a s/h one. You just want a heat gun to warm the pipes to soften them before pulling them off or trying to put them on again

 

[newhollandcruzr]

Thankyou all !!

 

[Alistair Nelson]

Hi Alistair , as you know your farm force stuff ! i have a 4m folding drill fixed to ultimate do you no if the distribution head cover is the same as an Accord ? many thanks

Think a may have seen one in the Agri-linc catalogue under Moore unidrill spares worth a call

 

[newhollandcruzr]

Ideal thankyou