Got a little leak on the suspension check valve ,, it 's the yellow thing in the photo , does it screw out , needs new o rings I think , tia @Speedstar etc etc
Sorry I do not know , an O ring may sort it if not it will need a new part of put up with oil leakGot a little leak on the suspension check valve ,, it 's the yellow thing in the photo , does it screw out , needs new o rings I think , tia @Speedstar etc etc
View attachment 1041832
Have you got a part number for the valve ? can't find it on jcb partsYep just unscrews but let the pressure off the suspension first by pulling on the spring rods both sides from underneath but mind you don’t trap your arms.wants a jcb seal kit really I have found .you might manage to find the right o ring though if your luckier than me !
Arms plant have the valve block , can't see that particular valve thoughIt’s on there for sure and on arms plant.charge valve it’s called in the hydraulic section with the spool slices.
Yes , you're right it isn't that one , I'm thinking it's just the o ring that needs changingThe picture above isn't it. They are a bad to get to seal don't over tighten they aren't much more than hand tight
I have resealed a two but had to put new on in the end
Just go underneath the machine and pull on the linkage for the suspension do both at the same time until it hits the bump stops then release and it should level itselfRight , so just needed a new o ring and leak cured , problem now is one side lift higher than the other
Need to equalise the pressure somehow , any suggestions .
@s~~t shoveller
Had a look , and nothing is jumping out at meJust go underneath the machine and pull on the linkage for the suspension do both at the same time until it hits the bump stops then release and it should level itself
Sent you a PMHad a look , and nothing is jumping out at me