Fit loader to Iseki T63/ Landini Globus or get rid?

[LongLaneWithTurnings]

Afternoon all.

I've a Iseki Tr63 which seems to be a version of the Landini Globus / MF - It's the 3.0 Perkins 4 Cylinder one.

I was hoping to fit a loader as, having seen an MF 872 loader on the lower powered MF 2210 thought it'd work quite well.

I acquired the full set of brackets for the MF 2210 but hadn't realised that was a 3 Cyl rather than a 4 Cyl and where the brackets meet the engine the holes are different - All the holes at the front are the same as my TR 63 - I've a rear subframe/bars that appears to fit.

With that in mind would you modify the MF 2210 brackets to fit , or flog the whole lot and start again?

I like the TR 63 its been an ideal size for me, mowing grass on 24ish acres, flailing verges etc but I understand it and the MF 2210 are rare and I dont want to cut up the brackets if someone with a 2210 could use the whole setup.

What would you do?

 

[LongLaneWithTurnings]

Edit to add that the MF 872 loader is also an ALO/Quicke Q 720

 

[Dave W]

I would get a fabricator to alter the brackets. You did well to find those and the chances of finding the correct ones are slim I would think.
loader looks like it’s missing headstock but should be easy to find

 

[LongLaneWithTurnings]

Thanks Dave, yeah it was a bit of luck just rounding up the brackets that are 'near enough' and the loader too.

I just drove up to the loader and It doesn't look a million miles away, think I might have to move the hydraulic pump feed and return and maybe /modify the auxillery fuel tank out front as its using the four front bracket bolt holes

It'd be incredibly useful to get this up and running.