Ford 4630 throttle linkage

[Andrew.w]

Does your 4630 have a cab on ? Mine does so that might change the lay out a little. Unfortunately when I bought mine it had a hard life. It’s rusted but the engine is solid and all the linkage and PTO work so it’s does the job for me. Do you have the 8x8 shuttle gearbox on yours. ?

Yea she has cab and 8x8 with dual power...just imported from the continent

 

[OJSligo]

Yup that's the same set up on the 4630, the spring is there but seem very light, may have been replaced at some stage

Heres pics of 5030 set up. End of throttle cable is spring loaded

 

[Andrew.w]

Heres pics of 5030 set up. End of throttle cable is spring loaded

That set up on the pump looks different, more robust, than on the 46...

 

[OJSligo]

That set up on the pump looks different, more robust, than on the 46...

Probably cos of the 4cyl engine

 

[Andrew.w]

Probably cos of the 4cyl engine

That would make sence

 

[Tibbo]

The 5030 has a different fuel pump. I have tried to re to fit that type of throttle cable to the 4630 but couldn’t make it work as an her point couldn’t alone and the starter motor was in the way. I do have one of those throttle cables now in the self if anybody is looking for one.

 

[Andrew.w]

Just to update on my sticky foot throttle...wd40 and some silicone spray sorted it out. Where the foot throttle pivots, just in behind the steering column, spayed it with wd40 and worked the throttle up and down and it came loose. Pain in the hole to get to. Impossible to get the front rubber cover off with out taking off the brake pedal and clutch pedal, that I could see anyway. Loader joystick didn't help either but just about able to get my hand in from the RH side...silicone spay then to keep it free moving.

 

[OJSligo]

Brilliant. Good to hear you have a resolution