Getting bearing off

copse

Member
Location
Rutland
Can’t get behind it to lever it off any ideas to get it off?
AEDA6AC0-19E3-4B4D-B5A6-D4712A27EBB4.jpeg
 
If you use hammer and chisel wear goggles... I made up a pullers to do similar job ... looks like a replacement bearing has been fitted sometime also looks like a cover is fitted so hiding grease point
 

Wesley

Member
Find a pair of longs bolts, grind either side of the head off to leave a T shape & that will fit between the two races. Push them through, turn 90 degrees & either use them in a puller or find a piece of steel & drill two holes so you can put it across the end of the shaft & use the bolts with nuts on as a crude bearing puller.
 

Phil P

Member
Arable Farmer
Location
North West
Can’t get behind it to lever it off any ideas to get it off?View attachment 1035324
Before you get carried away with the gas 🤦🏻‍♂️, put some safety glasses on then if there’s any of the bearing cage left use a punch between the balls to remove it.
Then raise the shaft so all the balls can drop to the bottom. You should then be able to just flick the balls out with a screwdriver and remove the outer and housing together.
Then if you can get on the centre with a grinder cut a slot as far as possible then use a chisel to split it if you can’t get in with the grinder try pullers and some gentle heat.
 
Last edited:
slide hammer or


or



I would be very careful about just trying to smash it out, there was a lecturer at Evesham Tech with a plate for his front teeth, I asked him why he was wearing a plate and he said he was smashing up a bearing (on a set of discs I think) in a field, and one of the bits flew up and took out his teeth.
 

Make Tax Digital Software Poll

  • Quickbooks

    Votes: 33 16.2%
  • Sage

    Votes: 20 9.8%
  • Xero

    Votes: 95 46.6%
  • Other

    Votes: 56 27.5%

Man fined £300 for bonfire-related waste offences

  • 215
  • 0
Written by William Kellett from Agriland

court-640x360.jpg
A man has pleaded guilty at Newtownards Magistrates’ Court to waste offences relating to a bonfire next to the electrical sub-station on the Circular Road in Newtownards, Co. Down.

Gareth Gill (51) of Abbot’s Walk, Newtownards pleaded guilty to two charges under the Waste and Contaminated Land (Northern Ireland) Order 1997, for which he was fined £150 each and ordered to pay a £15 offender’s levy

On June 25, 2018, PSNI officers went to Gill’s yard, where they found a large amount of waste consisting of scrap wood, pallets, carpet and underlay.

Discussion with Northern Ireland Environment Agency (NIEA) officers confirmed the site...
Top