Help with sprayer

[Try to succeed]

Hi folks. After a bit of help. I have a Leeb AX, whilst spraying this morning in auto, the pressure dropped to 0.8-0.9 bar. In manual I can increase the pressure, however it still shows a low pressure warning at 3+bar. Jug testing has show the blues are putting out 0.85L at 3bar instead of the expected 1.2L. I noticed the flow in L/min bounced a bit when going at a steady speed. I can get high pressures like normal in other services like induction bowl etc. I’m thinking the issue is the flow sensor, but why would that give an incorrect jug test in manual? Any suggestions gratefully received!

 

[Flatlander]

Does you rate controller take a speed signal from a gps unit or radar.

 

[Flatlander]

Read it again and I’d say you have a blocked filter of restriction someplace. Or you pump is not working right.

 

[Try to succeed]

Hi Flatlander. I think I found the cause as being the Arag unit in the recirculation valve. I’d seen the flow meter wasn’t tallying with the actual flow so assumed it was that not reading correctly. Turns out it seems it’s reading correctly but wasn’t all getting to the nozzles. V frustrating on what was lined up to be a big spray day!