Hydraulic Take Off Points on FE35

[Vizslaman]

I want to connect a pressure gauge to check the hydraulics on my FE35 to check the pressure before I go to the effort of overhauling the pump.
Doe's anyone have a diagram showing the 3 take off points ?
TIA

 

[Mydexta]

Does it not have a trailer tipping pipe????

 

[Vizslaman]

I have not found one.
At present the hydraulics are not working so just fault finding
I have only recently acquired it.

 

[Tigger]

I know one of the outputs which was used for the loader on mine, which is as shown by the yellow arrow in the photo below. Normally there's a blanking plug there which can be removed by use of an allen key (I think 5/16" size).

 

[MF-ANDY]

one port as shown in the above picture, one in the same place on the other side and one vertically above that. dont forget low pressure tested by screwing a gauge in any of these may not be a faulty pump. it could be leaking from the cylinder or stack pipe.