IH B414

[motrac3a]

I recently bought a B414 off a chap who works as mechanic for a large tractor dealership. He had fully overhauled the engine using a genuine CNH engine rebuild kit, fitted reconditioned injectors and pump. Engine had no water in it when I went to see it as it was mid January. It starts on the button and runs like a clock yet when I have got it home and put anti-freeze in it when left for a few days it blows water out of the exhaust. Any ideas on how the water is getting into the cylinders? Just a dodgy, ill fitting head gasket?

 

[REStracTORATION]

Head gasket i would say
Cant remember if these have the injector sleves tip a sealer in an see if it stops or retorque the head down for a start

 

[motrac3a]

Head gasket i would say
Cant remember if these have the injector sleves tip a sealer in an see if it stops or retorque the head down for a start

 

[motrac3a]

injector sleeves?? One injector was weeping and I nipped it up, can this unseat a seal?. Will have to get a workshop manual.

 

[Pennine Ploughing]

if new copper rings were fitted in the injector sleeves, then they should of been annealed to soften them to get a good seal, other thing to check if you have the head off, is they are prone to cracking in the block between the cylinders,