JD 6110 se return dump port location

[Logbrog]

Does it have one?
just had straw chopper installed , engineer couldn’t find free flow return.
ended up putting return in float in number 1 spool and pressure in number 2

 

[C.J]

Does yours have a section like this below the grey bit with the cooling fins on ?

If so its the lower right port with the black plastic plug.Behind the plastic is a allen key hole and the thread size is M22x1.5

 

[milkloss]

Just above the pto guard to the right? Another m22.

 

[KB6930]

Just above the pto guard to the right? Another m22.

Not on a 10 series

 

[Will 1594]

Will take you a pic in half hour

 

[Phil P]

Does it have one?
just had straw chopper installed , engineer couldn’t find free flow return.
ended up putting return in float in number 1 spool and pressure in number 2

If it’s an SE you’ll probably already have an elbow fitting in the return port, something like this

you’ll need to replace it with a T fitting and then put your coupler on that.
Hope that helps.

 

[Will 1594]

This any help

 

[Logbrog]

I assume the port with the pipe with jubilee on it?

 

[Phil P]

I assume the port with the pipe with jubilee on it?

That’s the one, need to replace the fitting with a T piece.

 

[Logbrog]

Been to dealer for t piece.
they said that port won’t work, oil will heat up due to restricted flow.
needs to go into filler cap, they have machined special adapter which I have ordered.
later models have a dump port down near filler cap, but not mine