JD 6120 fuel problem
- Thread starter rhifsaith
- Start date
Ioan annwyl
Member
Can you hear the pump in the tank working?
Hmm. No haven’t listened for that, the pump underneath the filters is working
- Location
- North West
If it’s an se? You’ll need to put the f/r leaver into drive then turn the key to the start position to energise the lift pump.
It’s a premium
Ioan annwyl
Member
Sorry did not read thread properly, if the pump under filters is working should fill filters in about a minute. No pump in tank?
Left key on for about 10 mins and still hadn’t filled them. With bleeds open
- Location
- Agricultural Engineer, Lancashire
Ah, therein lies your problem. The bleed screw slackened on the first filter would probably cause the pump to draw air given it draws fuel through the first filter then pushes it through the final filter heading towards the main injection pump. Shouldn't need the bleeders open for it to prime up if the pump is in good order.
- Location
- North West
As @jd6820 says, if it a common rail (2 filters) the bleed screw needs to be tight for the pump to prime. You should be able to hear the pump running with the ignition on, probably not from the cab though.
Also make sure you haven’t lost the O-ring off the glass bowl.
dieselboost
Member
That famous O-Ring...made the silly mistake once of replacing it with the one that comes with the filter thinking I was doing a great job!! That was until 2 hours later wondering why the warning light was coming on beside the steering column. After much review of the wiring to the moisture sensor and the filter insertion into the housings to find that my replacement of that O-ring on the glass bowl filter was the culprit. Learnt a lot about the fuel system that day!
dieselboost
Member
The O ring that comes with the filters in the box is for the drain screws on the bottom of each not for the seal between the glass bowl and filter as it is a different size.