jd greenstar

[fermec860]

running on sf1 with a 6000 dome for drill works very well but if you stop to fill up sometimes the line has moved can I shift it on the buttons or do I have to do a new ab line thanks

 

[CPP]

running on sf1 with a 6000 dome for drill works very well but if you stop to fill up sometimes the line has moved can I shift it on the buttons or do I have to do a new ab line thanks

You have a shift track option on screen
Which screen are you using
You may have to turn it on

 

[fermec860]

You have a shift track option on screen
Which screen are you using
You may have to turn it on

Touch screen in r series

 

[KB6930]

You just need to centre it to where you want it again with the button with 2 arrows pointing in towards a line in the middle I'll get a picture later

 

[KB6930]

Drive to where you want to be hit the button highlighted in blue and that will shift the line to the centre of the tractor again

 

[e3120]

I understand this effect with egnos when you stop for seed etc. Is it happening all the time when drilling, but not noticed, leading to wider/narrower tramlines?

Had a drill demo in the autumn and was told it was just running egnos. Very impressed with bout-to-bout matching but can't confess to have measured tramlines. I'm on the lookout for an ez-steer as a consequence.

 

[KB6930]

Unless your on full rtk you get a wee bit of drift depending on how long you're stopped for and what level of signal you're paying for

 

[fermec860]

,thanks for replies will try this in the spring when stopped for any longer than 20 minutes it did move 8 to 12 inches so I just di a new ab line it seems more accurate in straight mode but is fine on ab curve