John Deere 6145r hydraulic problem

[Pau1]

The hydraulics on my 6145r aren’t working... the link arms aren’t moving and the svcs aren’t working. oil levels are all good. Any ideas?!

 

[radu]

Is the steering working? Any fault codes?

 

[James 6920]

The hydraulics on my 6145r aren’t working... the link arms aren’t moving and the svcs aren’t working. oil levels are all good. Any ideas?!

Have you activated them through the command centre on start up??

 

[marcot]

Hit the hydraulic lock button by mistake?

 

[Pau1]

Thanks all, steering all fine, no error codes, tried the lock button. Command centre looks fine. Might it be a fuse? Not sure which fuse is the hydraulics?

 

[Hesston4860s]

Pump drive shaft sheared ?.

 

[Galcam]

Is yours a command pro ivt and if so did u change the initial screen that pops up on startup where u config the tractor for how u drive it?

 

[gpikcil]

Can you see on command center that SCV or Hitch bar changes when you activate tham?? Or it shows all the time in middle possition when you change?

 

[Pau1]

Hi all, thanks for your suggestions. After many hours of investigation by the main dealer it turns out there was a mouse nest under the cab and the mouse had eaten through the electrics ? I’m awaiting what I expect will be a significant bill!

 

[st piran]

Is yours a command pro ivt and if so did u change the initial screen that pops up on startup where u config the tractor for how u drive it?