kuhn 30.1 setting for calcifert.

[Sprayer 1]

Have got 350kg/ha of calcifert to put on, not used it before, and could do with a starting figure to start calibration with as in the little picture book of products there doesn't look anything similar . Does it run fast like N or more like a p&k. Any advice please.

 

[Brisel]

http://www.kuhn.co.uk/uk/online-services-calibration-charts.html

I couldn't see Calcifert listed.

 

[Chae1]

Think its on calcifert website

 

[Brisel]

Think its on calcifert website

http://calcifert.com/spreader-settings/
http://calcifert.com/media/1053/calcifert_spreader_testing-lime-all.pdf

 

[Chae1]

.

 

[Chae1]

Doesn't have flow factor.

 

[Brisel]

You can calibrate that easily enough with a bucket & scales.

 

[Chae1]

You can calibrate that easily enough with a bucket & scales.

That would involve getting off my arse though.

 

[Chae1]

Have got 350kg/ha of calcifert to put on, not used it before, and could do with a starting figure to start calibration with as in the little picture book of products there doesn't look anything similar . Does it run fast like N or more like a p&k. Any advice please.

How did you get on?

Do you have a flow factor? Going to spread some tomorrow.

 

[Sprayer 1]

The nearest product in the book I could find was potash k2, so started with a setting of 170 bot went down to 140 to apply 348kgh on drop point 5 . Didn't use the border spread except by the road which was on12.5 but not sure it did a lot.

 

[Flat 10]

I need a DOP for salostran 26N 13S please. Can’t see anything like it in charts. I would be very grateful. 24m S4 discs

 

[Chae1]

You can calibrate that easily enough with a bucket & scales.

Are you meant to have pto running to calibrate it?

Got it completely wrong. Ran it and weighed it. Got 0.7. Loaded 2 bags 1200kg, ran out at 800kg.

Ended up 1.05 was about right.

 

[Half Pipe]

Are you meant to have pto running to calibrate it?

Got it completely wrong. Ran it and weighed it. Got 0.7. Loaded 2 bags 1200kg, ran out at 800kg.

Ended up 1.05 was about right.

Yes, PTO should be running at required speed. Needs it running for agitator Todo it's job

 

[AF Salers]

Does anyone have a flow factor for Calcifert S? (This is for an Amazone ZAM)

 

[Brisel]

The Amazone website has one for another lime product. I used it a couple of years ago and it was close enough.