Conditioner bearings or end of conditioner tube weld let go. They Had problems with welds 7 or 8 years ago.
Check the top and bottom bushes where it pivots in the middle.The top and bottom bolts that hold the main beam to the mower will be worn and have too much play.Very simple job too changehi, can anyone help???
I've a kuhn centre pivot trailed mower, it has a bad vibration when you start to cut, its ok when not cutting when you lift it at the ends.... All the pto shafts seem tight, well greased. Any idea?????
thanks
Check the top and bottom bushes where it pivots in the middle.The top and bottom bolts that hold the main beam to the mower will be worn and have too much play.Very simple job too change
We tried that put 2 new bushes in and tightened up and was good again.The bolts do have a some play in them, will see if I can get them out to replace or pack them up. Thanks
We tried that put 2 new bushes in and tightened up and was good again.
Yes. Top and bottom bolts hold it on. Ours was vibrating like you say and we tightened the bolts up solid but you could still move the donut pto so we screwed out a bolt and found a bush in there. Replaced them and vibration disappeared.is it the bolts that hold the donut pto universal thing at the mower end of the drawbar???