Kverneland plough part

[ridger]

Where can I get this for the top link bracket? Currently the top link has to be screwed within an inch of its life to plough, then it gets dusty and rains, and is hard to screw back in to do anything else.

 

[Sausage]

Kv dealer I would think. Not a complicated part to have a go at making yourself, but it will need to be folded to bring the clevis gap back to the right width for the top link.

We had the same issue with our old 120 headstock, upgraded to a 160 (on a different plough) and much better.

 

[quattro]

Think I’ve got one if you can’t find one nearer

 

[Mrs Brown]

Isnt there double set of holes for the lower link bar, fit it in rear holes if it isn't in them already but do check there is enough room about the backend of tractor for plough to rotate without fowling.

 

[ridger]

Isnt there double set of holes for the lower link bar, fit it in rear holes if it isn't in them already but do check there is enough room about the backend of tractor for plough to rotate without fowling.

Had to move lower bar, because toplink was hitting turnover ram.

 

[ridger]

Think I’ve got one if you can’t find one nearer

Il buy it, whatever you need for it.

 

[quattro]

Il buy it, whatever you need for it.

I will look tomorrow to make sure I’ve still got it

 

[bravheart]

Longer top link?

 

[Vincent]

As above I have to use a MF top link with my 7810 on some implements as the ford one does be close to the end of the threads.

 

[Boohoo]

@ridger are you ploughing with a TM? Is the toplink the right length? Some places sell non genuine top links that they claim to be suitable for New Holland TS, TM etc etc but a TS top link is shorter.

 

[ridger]

@ridger are you ploughing with a TM? Is the toplink the right length? Some places sell non genuine top links that they claim to be suitable for New Holland TS, TM etc etc but a TS top link is shorter.

Yes a tm. It's the toplink that came with it, it's ok with every other implement apart from the ploo

 

[bravheart]

Perhaps get a longer top link get it set and leave it on the plough, sorted!

 

[ridger]

Perhaps get a longer top link get it set and leave it on the plough, sorted!

Only way to get a longer toplink would be cut it and weld a bit into it, a bracket like what's in the picture could stay on the plough the rest of its days and the toplink would fit everything else. However, if a bracket csnt be got il just work away as normal lol