Kverneland taarup 7558 wrapper problem
- Thread starter Adsloan
- Start date
Now flashing "error 3" on the display
- Location
- South Wales UK
Ask ur kverland rep.or dealer maybe too ?
milton-95
Member
- Location
- aberdeenshire
Error 3 , the sensor for counting the amount of turns isn't getting a signal, either it's not picking up the Magnet, the table is going to slow, the sensors broken or there's a broken wire to the sensor.
Can't remember what error 5 is with out looking at the book which I haven't got handy just now,
Have you got a good power supply to the box ?
Monty
Member
- Location
- Nantwich, Cheshire
Error 3: Max time between two rotation pulses on table is exceeded
Error 5: Turn table not in unload position
Error 5: Turn table not in unload position
The power supply should be ok, it's been working fine up to now at least
milton-95
Member
- Location
- aberdeenshire
Yes got it going, turned out to be a burst solder on the circuit board, wee did of solder and jobs done, thanks
- Location
- Cornwall
Quick question about these wrappers,
Should it be possible to start the auto sequence from the main control box, without the remote ?
I've been trying today but no joy !
Cheers
Should it be possible to start the auto sequence from the main control box, without the remote ?
I've been trying today but no joy !
Cheers
milton-95
Member
- Location
- aberdeenshire
Yes it should do. The bottom switch click it to the right where it says OK, that should start the cycle.
- Location
- Cornwall
Yes it should do. The bottom switch click it to the right where it says OK, that should start the cycle.
Haha, that's the one switch I didn't try ! Thought that would be more for setting programs and confirming options... never thought to just push it !!!
Thankyou, I will give it a try !
- Location
- Cornwall
So what does the 'auto' button on the left do then ??
- Location
- Ardrossan Ayrshire
If its the same box as the Kverneland you press it go back to work mode after adjusting parameters, resetting the counter etc
milton-95
Member
- Location
- aberdeenshire
If you want to change the amount of turn the table does to a cycle, you press select then use the plus/minus buttons to get to the number of turns you want then press auto and it then does the whole cycle automatically when you press OK on the remote control.
- Location
- Cornwall
- Location
- Cornwall
Ok, I'm back again!!
How do I get it to reset the wrap count to zero when it breaks the wrap and I stop it spinning to re attach.. without tipping the bale off and starting again ..
How do I get it to reset the wrap count to zero when it breaks the wrap and I stop it spinning to re attach.. without tipping the bale off and starting again ..
- Location
- Ardrossan Ayrshire
You should have a double arrow button near the auto and select button. Press this and she will return to the start of the program and also not count the aborted run as a bale.
- Location
- Cornwall
Ideal,
Cheers, I've finally gotten the hang of her !!
milton-95
Member
- Location
- aberdeenshire
Their good working wrappers and fairly simple to work once you understand the box. Can get a few mechanical niggles with them but usually it's a quick fix... any other questions just ask away
- Location
- Cornwall
The two buttons at the top of the remote..... I am using the one on the right (black outline) to run the auto cycle -no problem..
The one on the left .. I am guessing should run the auto wrap, but not tip it off ??
But I can't seem to get it to do anything ... the only use I have found for this button is to stop the system if the wrap breaks for example.. so it's obviously connecting to the receiver but not doing anything else ..
Am I correct in my assumptions, and anyone have any ideas why it wouldn't be working?
'cheers