Manitou MLT 634 oil leak small hole ?

[SteveO]

i have notices my Mamitou is dripping oil on the concrete and it goes on my nerves. It os coming from this small hole. I think it it GTL 85W90 oil. I am no mechanic so I can only make photo and ask if there is a simple solution ?

@ACEngineering as always is welcome

 

[Sparkplug]

If it's 80/90 it will be coming from the Angle Gearbox - so drive shaft comes through to drive Hydraulic Pump, and there must be a seal faulty. Where the hole is it should be a dry compartment.
If it's Hydraulic Oil it is the rear seal of the Hydraulic Pump - Leave the Boom Up tonight, so in the morning before starting the engine pull the Angle Gearbox dipstick out to check oil level.
Also go under machine with 13 mm spanner and take one screw out of the torque housing inspection cover and slacken the other, flip panel around, shine your torch inside and look for seal leaking at back of Torque Converter, check Torque Converter is not loose or sliding on the shaft in case locking tab / belville washer has broken - @ace will be along shortly to be more specific as to what your problem is.

 

[ACEngineering]

i have notices my Mamitou is dripping oil on the concrete and it goes on my nerves. It os coming from this small hole. I think it it GTL 85W90 oil. I am no mechanic so I can only make photo and ask if there is a simple solution ?

@ACEngineering as always is welcome

Oil seal in back of angle box leaking.
Drill it to 7mm and thread it for 8mm bolt!

Glue it in or as its covered in oil use ptfe tape.

??

 

[SteveO]

Are you kidding or for real ?

 

[ACEngineering]

Are you kidding or for real ?

Nope its a real fix

 

[SteveO]

hope it will hold till next owner