Metal hose tail repair

[Andrew]

One of the hose tails has snapped off the manifold on a Grammer seat. Any suggestions how to bodge it?
Thinking a roll pin to hold it and some glue to seal it but not sure it’d hold the air pressure

 

[Kevm]

Glue it back on with JB weld, scratch the flat surface first to give it a key.
You will have to build it up to maybe the lower ridge to get a good hold without losing too much hose attachment length.

 

[ACEngineering]

One of the hose tails has snapped off the manifold on a Grammer seat. Any suggestions how to bodge it?
Thinking a roll pin to hold it and some glue to seal it but not sure it’d hold the air pressure

View attachment 1042702View attachment 1042703

tap a thread in it and screws a new one in??

 

[box]

tap a thread in it and screws a new one in??

That.

 

[Farmer_Joe]

I like your roll pin idea I woild go for that

 

[chickens and wheat]

milliput

 

[Old apprentice]

As said roll pin then use a putty type product you mix it up it is in same roll two diferent products to get her I call it liquid metal goes hot when mixed then sets hard I repaired a deizel tank with it .
Quick steel is the name of the product is used comes in a small tube.

 

[cosmagedon]

Get a NPT hose tail then screw it in with some sealer.