MF 6400 series linkage reset

[Farmer_Joe]

my linkage ha been irritating me with code given out by flashing lights since i did the brakes, (linkage works perfect i suspect i tested something before i plugged everything back in) it seems to hold this code and after reading through loads of elec digrams the only way to clear the codes it appears is with a laptop.

thought i would see first by un pluging a draft sensor but it just logged another code and held it even when i plugged it back in and reset everything i could, so now i had 2 annoying sequences of codes flashing though linkage lighting.

after finding this i though i would re calibrate the linkage moment with the hope it would reset the codes AND YES it has,

just though i would stick it here for anyone having same issues in future save them reading though elec manuals!

 

[Matty6270]

my linkage ha been irritating me with code given out by flashing lights since i did the brakes, (linkage works perfect i suspect i tested something before i plugged everything back in) it seems to hold this code and after reading through loads of elec digrams the only way to clear the codes it appears is with a laptop.

thought i would see first by un pluging a draft sensor but it just logged another code and held it even when i plugged it back in and reset everything i could, so now i had 2 annoying sequences of codes flashing though linkage lighting.

after finding this i though i would re calibrate the linkage moment with the hope it would reset the codes AND YES it has,

just though i would stick it here for anyone having same issues in future save them reading though elec manuals!

Hi Joe.
im having problems with my 6475 lift from yesterday. read below. Could I try a calibration
I have a 6475 2008, lift stopped working yesterday. After I left it running a while it started back ok. But again today the lift stopped and is still the same. I have two light permanently lit on the lift control panel, attach pictur shows in blue. Them two lights should light up for 5 seconds and then turn off, this what the manual says. i have replaced the rocker switch on the arm rest and checked all lift buttons. Also check battery voltage
The fault triangle on the lift control does not light at any stage and no flashing error codes.
Pictures attached

 

[Farmer_Joe]

The lower light is transport mode I believe it puts the linkage in some sort of float to take bumps through the hydraulics while on the road. Not sure on other light

 

[davidroberts30]

The lower light is transport mode I believe it puts the linkage in some sort of float to take bumps through the hydraulics while on the road. Not sure on other light

the other light is to drop rate according to weight of implement

 

[daveydiesel1]

The top light if u turn the knob anticlockwise above it it should go out, the buttom light if u press the blister button below it it should go out

 

[Matty6270]

The top light if u turn the knob anticlockwise above it it should go out, the buttom light if u press the blister button below it it should go out

No the lights won’t go off. They are constantly on. Have checked rear fender buttons, rocker switch on arm rest, not sure what else to do

 

[daveydiesel1]

Try the calibration as a start. After that it may need a mechanics touch

 

[Matty6270]

Try the calibration as a start. After that it may need a mechanics touch

Tried the calibration but it doesn’t work. Lights dont change. Problem is that no decent mechanics In my area,

 

[daveydiesel1]

Only other option is ask the expert on here @dee