MF 6499 Spool Valves

[Pola]

Massey 11 reg Fingertip spools , the datatronic ones, have stopped working. The red light is flashing a code which im told is lack or no power going to the spools. They work ok manually by using the small levers on the block. Is there a Fuse ? In the book it says 3 & 4 are fused , but all 4 arnt working . What / where should I be looking .

 

[ih1455xl]

There’s a filter on the pilot line behind a Allen key bung on the spool block check that first then check the solenoid coil on the pilot line

 

[Pola]

I need a few pics to point me in the right place. Just to confirm the fingertips are electric , but wont now operate the 4 spools.
The blue button you have to press to activate them is now flashing a code
one flash slow
two flash slow
three flash slow
4 flash FAST

 

[ih1455xl]

 

[Pola]

Thanks. That’s not a 6499. I’m sure mines different
Will check Think my soloneid is in the middle of the block

 

[ih1455xl]

Middle of the block is lift arms this is on a 7480

 

[Lofty1984]

Can’t remember if they are all linked with cables like they are on a 77 if they are swap the cables around

 

[Pola]

They are different to the 77 I have. Just seems no power. As if a fuse has gone ?

 

[Lofty1984]

Had the same on our old 6480 but can’t remember what the problem was

 

[ih1455xl]

That’s

They are different to the 77 I have. Just seems no power. As if a fuse has gone ?

that’s linkage solenoid
look to the l/h side of the spool block

 

[ih1455xl]