Hi, Looking for ideas re: clutch on MF390T (serial no E18057). New clutch kit fitted june 2011 (Sparex) and has never been right and its gradually gotten worse. The issue is that you cannot get the tractor in gear - it doesn't grind it just doesn't go in without a lot of forcing. The clutch is not slipping either. With the tractor in gear the shuttle is almost impossible to engage into forward or reverse. Its a Highline cab with a clutch cable (been replaced already) and the clutch is fully adjusted to the end stop. If the shuttle is in neutral then can select gears no problem but cannot engage the shuttle then. I'm ready to split the tractor again and fit a new clutch kit but don't want to spend EUR800 and still have the same problem. Is it possible the supplied clutch was the wrong type?