Moore free standing retaining wall

[Dyffryn]

We have a big job about to start with this system doing silage pits. What is the best way to fit them?

 

[upnortheast]

Ask Moores
Usualy know what they are talking about

 

[Dyffryn]

The boss has done. Just wondering if anybody has some practical tips?

 

[Wishful Thinker]

@yin ewe your man.
Good even level base and will make the job awful lot easier.

 

[yin ewe]

@yin ewe your man.
Good even level base and will make the job awful lot easier.

Level base is half the battle and have a few steel or plastic packers to level the walls up if needed. Get a couple of steel bars to put through the holes at the top of the walls, and sling them into place using these bars. Might need to use a crowbar to tweek them a bit at the last.

 

[tjzservices]

Concrete panel will cut a bloke in half if it goes wrong, tread carefully x

 

[Dyffryn]

I went to give them a hand today fitting the walls. Why are they different sizes!? I’m convinced they have different moulds. You would think that they would be the same dimensions but they are not. Some were 20mm out.

 

[Nae bother]

I was thinking of buying ones for the end of my open ended silage pit but my cement floor dips in the centre for the drains,would it be a nightmare to fit them?and are moores ones the best?

 

[tjzservices]

I know i may be bias but mine are the best!!!
Please email for price
[email protected]

 

[zyklon]

I was thinking of buying ones for the end of my open ended silage pit but my cement floor dips in the centre for the drains,would it be a nightmare to fit them?and are moores ones the best?

If it’s like their slats, they will crack. Never had great faith in their stuff this past number of years. They have a habit of sending you seconds.

 

[Dyffryn]

I was thinking of buying ones for the end of my open ended silage pit but my cement floor dips in the centre for the drains,would it be a nightmare to fit them?and are moores ones the best?

Were putting them on a level concrete and it isn't easy.