New holland m115 lift arms not working.

[Martin LV]

Hi guys. I have a M115. My lift arms will not work from inside the cab but will operate no problem with the mudguard switches. I have a fault code 24 and than appears code 27. Any ideas? Thanks!

 

[DaraMulholland]

Fault code 24 is perform hydraulic lift calibration. Fault code 27 is Lift Arm Position Sensing Control Voltage Low (Short Or Open Circuit). Hope this helps.

 

[Martin LV]

Can U tell me how to calibrate hydraulic lift?

 

[Martin LV]

Fault code 24 is perform hydraulic lift calibration. Fault code 27 is Lift Arm Position Sensing Control Voltage Low (Short Or Open Circuit). Hope this helps.
Can U tell me how to calibrate hydraulic lift?

 

[DaraMulholland]

Try some of the things listed in these forums..

TM150 losing 3 point hitch calibration

My TM is being naughty, it loses it's calibration for no apparent reason. So far it's had a new potentiometer, a new EDC panel and the dealer has been over it. Any clues where to look? No error codes showing but it won't operate at all inside the cab, but can operate with the fender buttons...

farmingforum.co.uk

tm rear lift calibration?

Need to calibrate the rear lift on a tm 150 , how is it done

www.forum4farming.com

TM linkage calibration

So we have a slight problem. We started today to calibrate the linkage on our TM150. The reason was that she was only lifting to 97% and we couldn't get the hitch to go down. We done the following. Key off Unplug the wire from that pot Key on for a few seconds Key off and plug the wire back in...

thefarmingforum.co.uk