Got a loader put on the t7.235 last week, now noticed the first spool is acting up with this symbol on the screen, it will pump out but not retract, but will go into float. Doesn't seem to be doing anything to the front links. Will have to get the dealer to plug in I reckon, or am I missing something obvious?
New Holland sidewinder mystery
- Thread starter Dcol
- Start date
del_boy
Member
- Location
- Herefordshire
Is that telling you the lower stroke height has been limited? Have you any dials under the armrest you can play with
Ormond
Member
Our t7 200 has always had an issue with the spools, sometimes nothing will work and you have to restart the tractos....them at times the cross pad won't work . Very annoying if it's on the keenan.... About to feed out and have to restart...then the weigher says low battery... so have to get out and switch it off and back on
ridger
Member
- Location
- Tyrone, Northern Ireland
Think il keep my tm, if spool dont work, tighten the clamp lol
- Location
- Co antrim
Not a fan of elec spools
Looks like tractor has been setup for a loader, which will now expect spool 1 is connected to front links!?
Presume loader is connected to mid mounts that were originally connected to front linkage.
If front linkage and loader are now both connected to mid mounts then might need to disable loader setting, you will loose bucket shake function but rest should work.
Presume loader is connected to mid mounts that were originally connected to front linkage.
If front linkage and loader are now both connected to mid mounts then might need to disable loader setting, you will loose bucket shake function but rest should work.
Chae1
Member
- Location
- Aberdeenshire
There's a button on armrest. You can change mode of loader handle, front linkage control. It can be swapped to work spool valves. I'd check what mode its in.
Ormond
Member
Big difference depending on manufacturer. I find the NH ones difficult to feather, very notchy to put into float. Fendt ones are excellent imo
Thread resurrection, because that problem has come back from the dead and I don't know the cause or remember the remedy! Been at it the last hour and no clues. Was fine yesterday, it was moved into a shed with a mounted disc on (not by me) and now is as is. Very confusing.
Keep, maintain and cherish anything that’s pre Adblue and all the electronics. Better in your shed for a stand by and easily repaired
ridger
Member
- Location
- Tyrone, Northern Ireland
I keep a standby
Thepowerofdensil
Member
Check your hitch height limit dial is set off (fully anti clockwise) this can cause the spool to stop if it thinks the front hitch is at the maximum height already.
Michael3112
Member
One of ours done that an it was a 30second laptop job to change a setting. On ours it had decided the green rear spool was for the front linkage as it forgotten it had midmounts
That sounds familiar to the last time it happened, I'll ask the laptop man tomorrow. The green spool is still pumping out the back as normal, but the cross control on the multicontroller is tied to blue and brown now instead. Not a major problem at all, just annoying.
Michael3112
Member
Yea thats just the same ours done aswell but it had a software up dated before which had caused it
The London Palladium event “BPR Seminar”
This is our next step following the London rally 
BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth
Join us @LondonPalladium on the 16th for beginning of UK business fight back
lwtheatres.co.uk
BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth
Join us @LondonPalladium on the 16th for beginning of UK business fight back
BPR Summit | LW Theatres
lwtheatres.co.uk