New Holland

[Tanker44]

I drive a new Holland t6 180 started making a knocking noise at the back now the front wheels are locking up any ideas?

 

[Pringles]

I would say that it sounds like you have a collapsed wheel bearing. But this should not affect the front axle.

Get the tractor jacked up so that the wheels are just clear of the ground, make sure it is not in four wheel drive, then engage a low gear to find out if it is the rear axle that the noise is coming from.

 

[Tanker44]

It is the back axle even worse when I engage 4wd in hi and lo range

 

[Tanker44]

IT is still noisy when I free wheel like a clunking noise

 

[2wheels]

drive shaft to front axle knackered at rear end?

 

[Tanker44]

What would cause that?

 

[Lincsman]

Take off the front axle driveshaft and test.

 

[melted welly]

Have you been greasing that bearing on the driveshaft (that didn’t use to have a grease nipple fitted)?

 

[Tanker44]

Have you been greasing that bearing on the driveshaft (that didn’t use to have a grease nipple fitted)?

No I haven't it was serviced not long ago

 

[melted welly]

No I haven't it was serviced not long ago

Get underneath with a bar and see it you can move the shaft up and down. I’m assuming it’s still the same set up as puma 155/TM series had.

 

[Tanker44]

Still having trouble with Vicom rom spinner striping done a tray test was chucking 24m fine used the box to get granule size . Revs are constant set top link slightly shorter correct height from crop. Had all veins checked they are all right. Run out of ideas machine hasn’t been calibrated at all

 

[melted welly]

Still having trouble with Vicom rom spinner striping done a tray test was chucking 24m fine used the box to get granule size . Revs are constant set top link slightly shorter correct height from crop. Had all veins checked they are all right. Run out of ideas machine hasn’t been calibrated at all

Not getting any residue sticking to veins? Had a prob with inhibited urea leaving residue before.

 

[Tanker44]

Yes I am it’s not every field that stripes that’s what puzzles me

 

[Tanker44]

Not getting any residue sticking to veins? Had a prob with inhibited urea leaving residue before.

Been spreading 46% urea

 

[ridger]

What would cause that?

What was wrong with tractor that time?

 

[Tanker44]

Bearing collapsed on drive shaft going into front axle

 

[Tanker44]

What was wrong with tractor that time?

What was wrong with tractor that time?

Had to have another axle put on

Been spreading 46% urea

What does inhibited urea mean?

 

[melted welly]

Had to have another axle put on

What does inhibited urea mean?

It’s the coating they put on to slow the release of N. If you didn’t buy inhibited urea, you won’t of got it though.

 

[thesilentone]

Still having trouble with Vicom rom spinner striping done a tray test was chucking 24m fine used the box to get granule size . Revs are constant set top link slightly shorter correct height from crop. Had all veins checked they are all right. Run out of ideas machine hasn’t been calibrated at all

Where is it striping, behind the tractor or at the overlap ?

What did the prill test show you ?

 

[ridger]

Spreader could be set too wide, prills don't have to reach the next tramline as more are spread directly behind