Exactly. I've had good results setting tractor geometry in the yard on level concrete with an improvised plumb bob hanging off the pick up hitch. Chalk mark on the concrete one way, turn around, measure the difference and enter the tractor offset. Make sure the tire pressures are the same and the tilt compensation is calibrated correctly first though.First and easy thing to check. Drive up and down the same ab line and the tractor should drive up and down on exactly the same tyre marks. If it doesn’t then you start with tractor geometry . If it does then you start a new thread about drill offset. You then ignore 99% of the advice and take the only bit of advice. Use a tape measure!
Not really we found a bigger difference going to a 6000 dome on sf1 than sf2 on a 3000Anyone notice much difference between SF1 and SF2?
Not really we found a bigger difference going to a 6000 dome on sf1 than sf2 on a 3000
We bought it and a screen from another TFF member last yearHow much was the 6000 dome? You still use the original screen?