Plough Frog protectors

[sh40]

Notice the frogs are wearing down at the back above the landslide on my Overum cx plough. After doing a bit of research online there is frog protectors which can be put on.

Are these the correct ones in the link below. Also they only give the ones for the right hand side. Is there a different one for the left hand side?

A-Z Index : Malpasonline.co.uk

Tractor parts, spares and accessories for modern & vintage tractors. We are the largest UK online supplier of Sparex replacement parts and agri supplies

www.malpasonline.co.uk

Do these then just bolt onto the landslide?

 

[Bury the Trash]

Those in the link are landsides.

Keep landsides in good wearing order and the frog etc shouldnt wear other than maybe shine up a bit.

Yours will be XL bodies I would think, so order wearing parts accordingly.

 

[sh40]

OVERUM FROG PROTECTOR 23925 LH C/W BOLTS

OVERUM FROG PROTECTOR 23925 LH C/W BOLTS,XL

www.dhfarmmachinery.com

Are these the correct fellows so? can anyone explain how they actually protect the frog?

 

[davidroberts30]

Couple of passes with some hard facing rods

 

[Bury the Trash]

Or some old worn parts like cut in half landsides welded on with a couple of beads along the top of the frog, should hold them in place, it's not great draft forces there.

 

[Bury the Trash]

OVERUM FROG PROTECTOR 23925 LH C/W BOLTS

OVERUM FROG PROTECTOR 23925 LH C/W BOLTS,XL

www.dhfarmmachinery.com

Are these the correct fellows so? can anyone explain how they actually protect the frog?

They bolt to it and act like a taller bit of landside.

 

[RLC]

i got local engineers to plasma me some for dowdeswell out of hardox. Took a cardboard template and they were spot on. Not to mention 1/3 price of genuine.!

 

[2wheels]

i got local engineers to plasma me some for dowdeswell out of hardox. Took a cardboard template and they were spot on. Not to mention 1/3 price of genuine.!

did the same but just ordinary steel, but didn't split like the original cast ones and easy to weld up again.

 

[Will 1594]

i got local engineers to plasma me some for dowdeswell out of hardox. Took a cardboard template and they were spot on. Not to mention 1/3 price of genuine.!

We did that for our kv , before they wore back , depends if op has good steel firm local that can cut out the shapes

 

[sh40]

Have any of ye got pictures of the sections ye welded it on?