problem with Trimble 750

[eagleye]

when we turn it on it starts up and searches for satellites etc then fails and starts over again.
any ideas whats wrong?

 

[blue power]

Delete your Coverage on it to free up storage space that should sort it

 

[GPS_Support_2014]

If the last field created is 20km+ away then this can happen. It usually happens about 5-10 seconds after the satellite icon goes green.
You need to close the field before you travel away from it......to do this, go to make a new Field, and when it prompts “are you finished with current Field” press red X icon

 

[eagleye]

thanks for that, we have not more than 8 miles between farms.. but could be havent closed a field before
leaving

 

[GPS_Support_2014]

It can also happen if you have a narrow implement width and drive 8 miles from the original AB line. When the generated number of AB lines exceeds 2000 as you drive away and then you restart the display you might see a reboot.
Be sure to always close the field when you’re done and you’ll avoid the issue.