- Location
- sw scotland
Disappointing as should be done by the eye squinting at a row of blocks on the far wall.What lever?
The spirit level....
quick fixes, bodges and creations
- Thread starter jimmer
- Start date
Boohoo
Member
- Location
- Newtownabbey
It probably shouldn't be. I wasn't using it as a spirit level, it was the only straight edge I could findBut should that yellow instrument on the floor be in this thread?
RushesToo
Member
- Location
- Fingringhoe
In fairness, when you look at the detail it is questionable how useful it would be for its original purpose......
Boohoo
Member
- Location
- Newtownabbey
It's well used and abused! Persons who shall remain nameless have been known to use it to tamp concrete in around gate posts...
RushesToo
Member
- Location
- Fingringhoe
I can't imagine who that might be....
Cardboard aided design hi........
- Location
- northumberland
Right that’s it I’m off to make a big umbrella for the combine so we can cut in the rain [emoji57][emoji849]
- Location
- Northumberland
County-sized please.
Nearly
Member
- Location
- North of York
Mr Mackay
Member
- Location
- HMP Slade , Shropshire
Just mind your teeth !!
tomlad
Member
- Location
- nr. preston
Mine came with 2 small ratchets , quad sprayer
PuG
Member
- Location
- Languedoc-Roussillon
Ordered a water mister, which came with a pump and nozzles, 6m pipe and pick up for 29 euros Aliexpress. Came yesterday so set about wiring it up using an old electric fencer case and two IR sensors to trigger it on, old battery I found kicking around and simple relay. Idea is to give the cows some fly relief with citronela, garlic extract and lavanda oil mixed in the water. Pleased with the size of the plume, I want to hang it in our tunnel when the cows head back under the road daily to force them through it, but at the moment there kicked out in the woods so short of there curiosity hoping salt lick will lure them in!
Rod Dumbreck
Member
Is that an ultrasonic mister?
Good idea btw
Good idea btw
- Location
- our house, Norn Iron
Hy-gard bucket becomes pto guard extension.
Using the 540/1000 speed adapter on the grain dryer brings the shaft back a bit & the UJ is a bit more exposed, might raise an eyebrow with H & S but better than doing bugger all.
Using the 540/1000 speed adapter on the grain dryer brings the shaft back a bit & the UJ is a bit more exposed, might raise an eyebrow with H & S but better than doing bugger all.
PuG
Member
- Location
- Languedoc-Roussillon
No, but the parts:
Page Not Found - Aliexpress.com
www.aliexpress.com
2.22￡ |3V 5V Low Control High Voltage 12V 24V 36V switch Mosfet Module for Arduino Connect IO MCU PWM Control Motor Speed 22A
Smarter Shopping, Better Living! Aliexpress.com
www.aliexpress.com
Cheers
- Location
- Ardrossan Ayrshire
If this happens again, and you can access the valve, screw the end cap off, insert a small stone and screw the cap back on. This should hold the plunger against the cone in the same way the ball arm does. Have done it myself plenty of times.
Larel
Member
That’s a much tidier bodge, I love it!
Gerbert
Member
- Location
- Dutch biblebelt
I use empty bottles as floaters if needs must. Or tie the arm up...
Larel
Member
Pic doesn’t show it but it’s the arm that broken off, not the ball.