Reekie 350 webs

[Jinty Mcginty]

Any one know what the belt width on a Reekie 350 first web should be originally .Having bother with stones getting in the bed between frame and web .Gap between frame and edge of belt is almost 30mm remaining width of belt about 52mm
Annoying thing is bars in not bad nick it a 36

 

[Lincs Lass]

Would have the webs should be slightly wider ,,if the reekie harvesters were anything to go by ,those webs fitted snug between the carrier rollers

 

[legin]

Speak to Andrew Scott machinery, knows Reekie's inside out.

 

[KennyO]

Side frames are probably worn / pushed out too. You could plate them?

 

[Jinty Mcginty]

Side frames are probably worn / pushed out too. You could plate them?

Side plates are pretty good order and straight i measured the center belt and it was nearer 70mm Plating would be cheaper than another web

 

[Always wandering]

Any one know what the belt width on a Reekie 350 first web should be originally .Having bother with stones getting in the bed between frame and web .Gap between frame and edge of belt is almost 30mm remaining width of belt about 52mm
Annoying thing is bars in not bad nick it a 36

If your webs are 36 mm and the gaps 30 surely not the problem unless long thin stones are you sure stones are going down sides as from pictures it looks ok seen a lot worse with no problems

 

[ridger]

Are you working on a sidecast

 

[Jinty Mcginty]

Are you working on a sidecast

most off the time its a side sloping field

 

[ridger]

most off the time its a side sloping field

Aye put her up a gear and go ahead lol