rc mx110
Member
Its about 10-15mm. It goes to an elbow into th bottom of the boxA big hydraulic steel pipe or a little steel brake pipe ..........
Were you using the brakes again?
Its about 10-15mm. It goes to an elbow into th bottom of the boxA big hydraulic steel pipe or a little steel brake pipe ..........
Were you using the brakes again?
Feck knows I only know where the dipper is cos the fitter showed me.That's what that is.
Ok then smarty pants, on the gearbox left side there's a steel pipe heading upwards, where does it go?
You need the longer version of the stick. It was an option for scraper tractors.Feck knows I only know where the dipper is cos the fitter showed me.
Just to right the balance of me been a mechanical numpty on this thread he did look very dissaproving when there was no oil on the stick he had just shown me
A blocked breather can cause that.Is that a pipe that stick up into cab?
If what I'm thinking dip stick is ment to be in there, oil some times come out of there if too much oil
Took me a second to figure that outYou need the longer version of the stick. It was an option for scraper tractors.
Would appear your right @multi power this was December '16View attachment 439962
Tidier than a lot of scraper tractors
View attachment 439964
No 1 inlet was a bit slack so tappets were set
View attachment 439966
I had this mayonnaise on my sarnies at lunchtime.
View attachment 439968
Little bit of carbon