Setting tappets

Mydexta

Member
Location
Dundee/angus
Away to re time the 23c engine on my fe35 and have heard that the valve timing can be done by setting the tappets.

Can anyone give me a guide on how to set tappets. I have heard of the rule of 9 and various other ways but can someone point me in the right direction as I need to be as accurate as possible
 

Pennine Ploughing

Member
Mixed Farmer
To set the timing chain, follow this procedure…
To set the camshaft, first of all, set the tappet clearance on number 8 valve (the valve at the back of the engine closest to the steering wheel) to 0.023in (when the cam and rocker is in its lowest position). Then set number 7 valve to 0.025in.
Turn the engine away from TDC. (The keyway in the front of the crankshaft [that holds on the front pulley] is at the bottom when cylinders 1 and 4 are at TDC.) Therefore position the keyway on the right looking at the front of the engine (ie. 3 O’clock position – always turn it clockwise). You do this so that the pistons do not hit the valves.
Now remove the timing chain, camshaft sprocket and the chain tensioner.
Next turn the camshaft clockwise until vavles 7 and 8 are “on the rock” (ie. exhaust just closing, inlet just opening). Now the camshaft is in the correct position for the timing procedure.
It is now safe to move the crankshaft clockwise for number 1 cylinder to be on TDC. You can determine TDC without using the flywheel marks (ie. with engine connected to transmission) by using the flywheel pin hole as a reference point. Slide in the pin to the locating hole in the flywheel and then fix a protractor to the crankshaft, and place a pointer on the engine which will give accurate readings on the protractor. Then remove the flywheel pin and turn the engine clockwise 16 degrees (as measured on the protractor), and therefore you are now on TDC for number 1 cylinder and are in the correct position to fit the timing chain, sprocket and tensioner.
Now don’t forget to re-set valves 7 and 8 to their normal running valve clearances
 

Mydexta

Member
Location
Dundee/angus
Hi

Thanks for that, that's the instructions I have for doing it but its just the setting of the tappets I need help with, not sure when I should be setting the clearances. Someone said I could just start at no1 and when it was open set it then rotate the engine until no2 was open and set it etc etc

Does this method work or is there a better way to do it
 

SFI - What % were you taking out of production?

  • 0 %

    Votes: 79 42.0%
  • Up to 25%

    Votes: 66 35.1%
  • 25-50%

    Votes: 30 16.0%
  • 50-75%

    Votes: 3 1.6%
  • 75-100%

    Votes: 3 1.6%
  • 100% I’ve had enough of farming!

    Votes: 7 3.7%

Red Tractor drops launch of green farming scheme amid anger from farmers

  • 1,291
  • 1
As reported in Independent


quote: “Red Tractor has confirmed it is dropping plans to launch its green farming assurance standard in April“

read the TFF thread here: https://thefarmingforum.co.uk/index.php?threads/gfc-was-to-go-ahead-now-not-going-ahead.405234/
Top